FAQ
Linhai Baiai Metal Forgings Co., Ltd.
Adjusting shim method
Fill a set of soft material (soft steel or elastic paper) gaskets between the bearing end cover and the end surface of the bearing seat; when adjusting, first install the bearing end cover without placing the gasket, and tighten the bearing end cover evenly on the same side. Screw, while turning the shaft by hand, until the bearing rolling element is in contact with the outer ring and there is no gap inside the shaft; at this time, measure the gap between the bearing end cover and the end surface of the bearing seat, plus the shaft required by the bearing in normal operation Toward the gap; this is the total thickness of the gasket to be filled, and then fill the prepared gasket between the bearing end cover and the end face of the bearing seat, and finally tighten the screws.
SUBSCRIBE TO
OUR NEWSLETTER
Address: Auli, Dudong Village, Duqiao Town, Linhai City, Zhejiang, China
Customer service：+86-576-80255026
Phone：+86-15325762762
E-mail：baiai_factory@163.com
Weng manager (Domestic market)：